Blisstool LTC48 Guía de usuario descargar pdf (Pagina 11)

9. Device adjustment and preparation for work

The metal detector is ready for use when the battery is charged (the BAT LOW indicator is not

lit up).

Before the initial usage, please charge the battery for minimum of 8 hours, by using the

automatic battery charger available in the standard pack, according to the description in 11.

The built-in battery ensures up to 48 working hours without recharging.

After the metal detector is assembled according to the description in 7, it can be turned on via

turning the VOLUME/POWER knob from left (position OFF) to right.

This knob also serves for adjusting the desired audio volume control.

The GROUND switch is used for switching between the manual and the automatic mode for

eliminating the ground interference, according to the description in 8.2.

When choosing the manual ground balance, the device should be balanced according to the

description in 8.3.

The discrimination level and depth of discrimination (for distinguishing the metals) is adjusted

with the DISCR knob according to the description in 8.5.

DISCR has to be turned to “0” level, if aiming at detection of all metals. DISCR has to be

turned from “6” to “10” level, when aiming at ignoring the ferrous metals (detecting only non-

ferrous metals). The higher the level, the better ignoring of the heavily corroded iron is

achieved, and the metals are discriminated at a greater depth (depth of discrimination).

And lastly, the THRESHOLD knob adjusts the audio threshold to the desired level.

With this, the metal detector is adjusted and ready for work.

BLISSTOOL LTC48 – User Guide (version EN200908131904) Page 11 of 15

1 2 ... 6 7 8 9 10 11 12 13 14 15

Sin comentarios

Blisstool LTC48 Guía de usuario Pagina 11